Recent changes
Track the most recent changes to the wiki on this page.
List of abbreviations:
- N
- This edit created a new page (also see list of new pages)
- m
- This is a minor edit
- b
- This edit was performed by a bot
- (±123)
- The page size changed by this number of bytes
15 May 2024
|
|
N b 22:09 | (valve) is too busy! (1 pending operations) 2 changes history +1,577 [Jim.Wilson (2×)] | |||
| b |
|
22:09 (cur | prev) −1 Jim.Wilson talk contribs | |||
| N b |
|
22:08 (cur | prev) +1,578 Jim.Wilson talk contribs (Created page with ":'''<valve> is too busy! (1 pending operations)''' This error message may be displayed when the CEGS application is restarted after an unexpected shutdown. The error is raised when a solenoid valve is in an unexpected state. Almost always, this occurs when the software valve state is opened but the physical valve is actually closed. The easiest way to correct the problem is to interact with the application user interface to "close" the valve. A possible complic...") Tag: Visual edit: Switched | |||
| 15:57 | Actuator Frame 4PV Creation diffhist 0 73.24.216.92 talk | ||||
14 May 2024
| 18:06 | Actuator Frame Bearing Blank Creation diffhist +603 73.24.216.92 talk (new method) | ||||
|
|
17:43 | CEGS Creation 2 changes history +166 [73.24.216.92 (2×)] | |||
|
|
17:43 (cur | prev) +58 73.24.216.92 talk (→Meters - Preliminary Settings: Added nominal values for 30 PSI sensors) | ||||
|
|
17:22 (cur | prev) +108 73.24.216.92 talk (→Integration: Edited the Gas Supply Tests section with more specific instructions for the Test() function) | ||||
| 16:13 | GR TC Tip diffhist −402 73.24.216.92 talk (Blanked the page) | ||||
| N 16:13 | GR TC Tip Creation diffhist +419 73.24.216.92 talk (Created page with "* Cut a blank out of SS304 tube 1/8 x 035 seamless that is ~.540 * Face part to (.500-.525) * Chamfer both faces * Use .065 bit to drill 3/16 into the part * Chamfer by using a #00 bit * Turn the wheel on the arm so that the bit is sticking out by less than half an inch * Put the bit deep into the collet * Touch the bit to the part * Tap with a M1.6 x .35 * Clean the part * Crush the back half of the part in a vice") | ||||