Jump to content

Phase Separator Rod Creation

From Aeon HACS Wiki
Revision as of 13:05, 25 April 2024 by 73.24.216.92 (talk)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
  1. Cut rod to 14.084
  2. Use the large calipers to mark the part 7.821 from the end
    1. Use an exacto blade to mark the position
    • The mark just needs to be visible not deep
    • Place a black dot near the mark
    • We will call this measured section leg a
  3. clamp the bender in a vice
  4. place leg a into the bender so that leg a is being held stationary while leg b is being bent
  5. Place leg a in the bender and line up the mark on the rod with the center of the 0 mark on the bender
  6. Make a 90 degree bend
    • push slightly past 90
  7. Use swagelok bender
  8. Check to make sure it is square