Jump to content

Phase Separator Rod Creation

From Aeon HACS Wiki
  1. Cut rod to 14.084
  2. Use the large calipers to mark the part 7.821 from the end
    1. Use an exacto blade to mark the position
    • The mark just needs to be visible not deep
    • Place a black dot near the mark
    • We will call this measured section leg a
  3. clamp the bender in a vice
  4. place leg a into the bender so that leg a is being held stationary while leg b is being bent
  5. Place leg a in the bender and line up the mark on the rod with the center of the 0 mark on the bender
  6. Make a 90 degree bend
    • push slightly past 90
  7. Use swagelok bender
  8. Check to make sure it is square