Jump to content

Phase Separator Pad Creation: Difference between revisions

From Aeon HACS Wiki
added about this item link to nav bar
Added procedure to use the manual mill to create the hole
 
Line 3: Line 3:
|about=Phase_Separator_Pad
|about=Phase_Separator_Pad
|product=phase+separator+pad}}
|product=phase+separator+pad}}
# Cut 4.5 inch squares on the paper cutter.
# Cut 4 inch squares on the paper cutter.
# Lay the square on a scrap of XPS foam. (the pink stuff)
# Lay the square on a scrap of XPS foam. (the pink stuff)
# Use a ruler to center the 1 inch hole knife on the square.
# Use a ruler to center the 1 inch hole knife on the square.
#* 1.75 inch from hole knife to edges.
#* 1.75 inch from hole knife to edges.
# Twist the hole knife back and forth through the square.
# Twist the hole knife back and forth through the square.
Alternatively, use the manual mill to create cleaner holes
# Hold a piece of XPS foam in the mill vise
# Place the hole knife in a chuck on the mill, with a square of fabric below it
# Use the mill's distance measuring tools to center the hole knife on the square.
# Turn on the mill and sink the hole knife into the foam to create the hole.

Latest revision as of 12:12, 11 April 2024

    3D Model    About this item    Product info

  1. Cut 4 inch squares on the paper cutter.
  2. Lay the square on a scrap of XPS foam. (the pink stuff)
  3. Use a ruler to center the 1 inch hole knife on the square.
    • 1.75 inch from hole knife to edges.
  4. Twist the hole knife back and forth through the square.

Alternatively, use the manual mill to create cleaner holes

  1. Hold a piece of XPS foam in the mill vise
  2. Place the hole knife in a chuck on the mill, with a square of fabric below it
  3. Use the mill's distance measuring tools to center the hole knife on the square.
  4. Turn on the mill and sink the hole knife into the foam to create the hole.