Phase Separator Pad Creation
- Cut 4 inch squares on the paper cutter.
- Lay the square on a scrap of XPS foam. (the pink stuff)
- Use a ruler to center the 1 inch hole knife on the square.
- 1.75 inch from hole knife to edges.
- Twist the hole knife back and forth through the square.
Alternatively, use the manual mill to create cleaner holes
- Hold a piece of XPS foam in the mill vise
- Place the hole knife in a chuck on the mill, with a square of fabric below it
- Use the mill's distance measuring tools to center the hole knife on the square.
- Turn on the mill and sink the hole knife into the foam to create the hole.