All public logs

Combined display of all available logs of Aeon HACS Wiki. You can narrow down the view by selecting a log type, the username (case-sensitive), or the affected page (also case-sensitive).

14:28, 12 August 2024 Gilchrist.gbele talk contribs created page Mains Detector Creation (Created page with "# If using a 6ft usb A-B cable, cut the cable at the usb B side. # Remove about 2" of cable insulation. #* Using an x-acto blade mark a ring around the cable at the length to be removed. #** Typically a shallow mark here is desired - the goal is to weaken the insulation, not slice through it completely potentially damaging the wires inside. #* Bend the cable at this mark and use the blade to gently finish separating any still connected insulation. #* Slide the now separa...")
14:28, 25 July 2024 Gilchrist.gbele talk contribs created page Servo Bottom Serial Creation (Created page with " # Insert the servo bottom block (TL-SBB) into the cover. # Use the cnc mill to mill the servo bottom # Use the program named "rs232 servo bottom" # Mark pin 1: # Mill a .04 OD x 0.015 deep, 0.125" to the side of pin 1, aligned vertically with the row of pin centers. # Trim the ridges of the cover to provide clearance for the DSMC PCB along the sides and on the end beside the connector cutout")
14:25, 25 July 2024 Gilchrist.gbele talk contribs created page Servo Bottom CPW Creation (Created page with "# Use the MV35 program for the servo bottom CPW # Use a .04 bit to mark near the ground pin")
15:49, 17 July 2024 Gilchrist.gbele talk contribs created page 3D printing, filament (Created page with "=Changing the filament= # select unload filament # select the material currently loaded # wait for the printer to heat up # press the knob then pull the filament out # if switching to a different material then press x after this ## after selecting autoload select the material that is going to be loaded # auto load # load the new filament # make sure the color is correct # (if the type of filament is changed then there settings on the super slicer need to be changed)")