Jump to content
Inline LN Phase Separator Shroud Creation
- Grab heatshrink 1/2 2:1 clear, and cut a desired number of 4 inch pieces on paper cutter.
- Using the inline PS forming tool, slide the stock down over the top of the tool.
- Slide the outer shell over the forming tool (The black tube that comes in the forming tool bag).
- Use a scrap piece of FEP tubing, and slide it over the metal end of the tube to ensure the stock form to small.
- Slide the stock shroud over the FEP tube so the top of the funnel aligns with the cut line groove on the metal.
- Use the heat gun to form the heatshrink evenly around the FEP tube and forming tool.
- Try not to heat for too long at risk of melting the plastic tool.
- Slide the funnel off of the forming tool and remove the FEP tube.
- Repeat for all shrouds.