Jump to content

Heater Controller Stack Creation

From Aeon HACS Wiki
    3D Model    About this item    Products

Instructions

heater controller stack exploded view
heater controller stack exploded view
  1. Open the item database and locate the specific configuration you are building.
  2. Collect the correct number of circuit cards, the appropriate screw sizes listed in the bill of materials, and the required quantity of nylon separators.
  3. Assemble the item according to the CAD model (click the "Model" link on the item page).

Notes

  • The procedure for all configurations of this item is the same, only the number of circuit cards changes.
  • When collecting the parts, pay particular attention to the required quantity of each part and the length of the screws.
  • The screws pass freely through the CCAs and spacers and thread into the standoffs.