Jump to content

Actuator Coupling 4PV Creation

From Aeon HACS Wiki
Revision as of 15:14, 3 February 2025 by AddisonSterner (talk | contribs) (Added new parting procedure)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
    3D Model    About this item    Product info

Instructions

3d model of an actuator coupling 4PV.
Actuator coupling 4PV
  1. Cut Acetal Black Rod 750 on table saw to 1.7 inch.
  2. This part is milled in the MV35, follow the instructions within the program.
    Use the table saw and the actuator coupling parting tool 750 (TL-ACPT750) to part the piece.
  3. Use the coupling drill fixture 0.75 in the mill to make a cross hole.
    0.285 inch from the top face create a 0.128 inch hole that goes all the way through the coupling.