Actuator Controller Stack Base Creation
Instructions
- Prepare the CCA Servo Mux 8 Channel:
- Place the CCA Servo Mux 8 Channel on a clean, flat surface.
- Attach the 4 nylon standoffs to the four corners of the CCA Servo Mux 8 Channel. These standoffs will act as legs to elevate the card and connect it to the control section panel.
- Connect the CCA Device Mux Selector:
- Position the CCA Device Mux Selector perpendicularly to one end of the CCA Servo Mux 8 Channel.
- Align the connectors on both cards and securely attach the CCA Device Mux Selector to the CCA Servo Mux 8 Channel using the appropriate screws and connectors.
- Attach the CCA Actuator Controller:
- Position the CCA Actuator Controller above the assembly so that it aligns perpendicularly to one end of the CCA Device Mux Selector.
- Ensure that the CCA Actuator Controller is parallel to the CCA Servo Mux 8 Channel.
- Securely connect the CCA Actuator Controller to the CCA Device Mux Selector using the appropriate screws and connectors.
- Final Check:
- Verify that all components are securely attached and properly aligned.
- Ensure that the connections between the circuit cards are firm and that there are no loose parts.