Jump to content

Actuator Frame 6PV Creation

From Aeon HACS Wiki
Revision as of 17:05, 24 July 2024 by Oscar (talk | contribs)
    3D Model    About this item    Product info

Instructions

  1. Tapping the Frame Servo Mounting Holes:
    Clamp the frame end-to-end into a vice with the bottom facing up.
    Place the appropriate tool on the bottom of the frame.
    Use a power drill and a 6-32 tap to tap the four frame servo mounting holes.
    Ensure that all metal shavings are thoroughly cleaned from the frame before proceeding.
  2. Attaching the Frame to the Servo:
    Securely attach the frame to the servo as per the assembly guidelines.
  3. Bending the Frame Tabs:
    Pinch the corners of the frame tabs to open them up to just wider than 1.125 inches using the specified setup.
    The position of the handle used to open the tabs should be consistent for uniformity.
    Use a vice to carefully squeeze the tabs closed until they fit snugly.