LN Manifold Body 9 Port Creation
Appearance
Work offsets
- O0014: fence
Programs
- O0761: cover
- O0762: cavity
- O0763: port holes
Tooling
- T0002: 7/32 end mill, 4-flute
- T0009: 0.125 drill
- T0011: 0.078 end mill, 3-flute
- T0015: 1/8 end mill, 2-flute
- T0016: 0.25 end mill, 2-flute
- T0017: 3/8 end mill, 2-flute
- T0018: 1/2 end mill, 2-flute
- T0021: 1 x 4 end mill, 2-flute
- T0023: 0.180 drill
Stock (inches)
- Blank: 9.75 x 2.75 x 5.5
Finished dimensions (inches)
- Lid: 9.75 x 2.75 x 1.25, w/ 0.1875 holes
- Body: 9.75 x 2.75 x 4.0, w/ 0.5 holes
Instructions
- Reference face: left
- Run 'lid' on top face
- Separate lid from body using bandsaw
- Part lid at 1.25"
- Size body to 4"
- Run 'cavity' on top face of 'body'
- Run 'stem holes' on back face of 'body'
- (CHECK TO SEE IF TOOL 23 HAS THE CORRECT TOOL LOADED BEFORE RUNNING THIS)
- Run 'drain holes' on bottom face of 'body'
- Run 'lid 2nd op' on right face of 'body'