Actuator Coupling 4LFV Creation: Difference between revisions

Revision as of 15:18, 28 May 2024

Cut blanks on table saw to 1.7 inch.
3d model of a actuator coupling 4LFV.
This part is milled on the MV35, follow the instructions within the program.
Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole.
- .285 inch from the top face create a .107 inch hole that goes into the center cavity.
Use a 6-32 tap to thread the hole.
Insert screw 6-32 x 1/4 SS SS (92311A144)

@@ Line 4: / Line 4: @@
 |product=actuator+coupling+4LFV}}
 # Cut blanks on table saw to 1.7 inch. [[File:Actuator coupling 4LFV 3d model.png|alt=3d model of a actuator coupling 4LFV.|thumb|3d model of a actuator coupling 4LFV.]]
-# Follow the steps inside of the coupling instructions.
+# This part is milled on the MV35, follow the instructions within the program.
 # Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole.
-# .285 inch from the top face create a .107 inch hole that goes all the way to the center of the previous hole.
+#* .285 inch from the top face create a .107 inch hole that goes into the center cavity.
-# Use 6-32 x 1<nowiki>/</nowiki>4 tap to thread the hole.
+# Use a 6-32 tap to thread the hole.
 # Insert screw 6-32 x 1/4 SS SS (92311A144)