Furnace Carriage Kit Creation: Difference between revisions
No edit summary |
No edit summary |
||
Line 5: | Line 5: | ||
=== Instructions === | === Instructions === | ||
[[File:Furnace carriage kit | [[File:Furnace carriage kit sample (onshape).png|alt=Furnace carriage kit sample (onshape)|thumb|Furnace carriage kit]] | ||
# Insert all t-nuts | # Refer to the model to determine the number of furnaces. | ||
# Insert all 8-32 t-nuts into the 8020 strut. | |||
# Slide in a 10-32 offset SS t-nut, two per 8020 bar, on each end. | # Slide in a 10-32 offset SS t-nut, two per 8020 bar, on each end. | ||
#* The short end goes on the outside. | |||
# Using a flat surface, attach the carriage end plate to both sides of the 8020 stock with the tabbed side on the same side as the offset t-nuts. | # Using a flat surface, attach the carriage end plate to both sides of the 8020 stock with the tabbed side on the same side as the offset t-nuts. | ||
# Screw the carriage end plates in and confirm that the assembly is flat and the 8020 bars are not rotated in place. | # Screw the carriage end plates in and confirm that the assembly is flat and the 8020 bars are not rotated in place. | ||
# Assemble the 8020 sliding lock | # Assemble and attach the v-wheels to the offset t-nuts. | ||
#* Leave these loose so that they can be positioned. | |||
# Attach the carriage to the CEGS frame using an 8020 sliding lock. | |||
#* Do not forget to install the carriage stops above and below the slide lock. | |||
#* Check that when the slide lock is tightened the metal tab of the carriage end plate does not make contact with the metal of the CEGS frame. |
Revision as of 11:21, 15 August 2024
Instructions
- Refer to the model to determine the number of furnaces.
- Insert all 8-32 t-nuts into the 8020 strut.
- Slide in a 10-32 offset SS t-nut, two per 8020 bar, on each end.
- The short end goes on the outside.
- Using a flat surface, attach the carriage end plate to both sides of the 8020 stock with the tabbed side on the same side as the offset t-nuts.
- Screw the carriage end plates in and confirm that the assembly is flat and the 8020 bars are not rotated in place.
- Assemble and attach the v-wheels to the offset t-nuts.
- Leave these loose so that they can be positioned.
- Attach the carriage to the CEGS frame using an 8020 sliding lock.
- Do not forget to install the carriage stops above and below the slide lock.
- Check that when the slide lock is tightened the metal tab of the carriage end plate does not make contact with the metal of the CEGS frame.