Actuator Coupling 4LFV Creation: Difference between revisions
No edit summary |
No edit summary |
||
| Line 3: | Line 3: | ||
|about=Actuator_Coupling_4LFV | |about=Actuator_Coupling_4LFV | ||
|product=actuator+coupling+4LFV}} | |product=actuator+coupling+4LFV}} | ||
== Instructions == | |||
[[File:Actuator coupling 4LFV 3d model.png|alt=3d model of a actuator coupling 4LFV.|thumb|3d model of a actuator coupling 4LFV.]] | |||
# Cut blanks on table saw to 1.7 inch. | |||
# This part is milled on the MV35, follow the instructions within the program. | # This part is milled on the MV35, follow the instructions within the program. | ||
# Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole. | # Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole. | ||
Revision as of 13:20, 3 July 2024
Instructions
- Cut blanks on table saw to 1.7 inch.
- This part is milled on the MV35, follow the instructions within the program.
- Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole.
- .285 inch from the top face create a .107 inch hole that goes into the center cavity.
- Use a 6-32 tap to thread the hole.
- Insert screw 6-32 x 1/4 SS SS (92311A144)