Jump to content
Toggle sidebar
Search
Create account
Log in
Personal tools
Dark mode
Create account
Log in
Pages for logged out editors
learn more
Contributions
Talk
Navigation
Main page
Recent changes
Random page
Help about MediaWiki
Tools
What links here
Related changes
Special pages
Page information
Editing
VTC
(section)
Page
Discussion
English
Read
Edit
Edit source
View history
More
Read
Edit
Edit source
View history
Warning:
You are not logged in. Your IP address will be publicly visible if you make any edits. If you
log in
or
create an account
, your edits will be attributed to your username, along with other benefits.
Anti-spam check. Do
not
fill this in!
==Tubing== The VTT body is machined from a block of extruded polystyrene foam (XPS). XPS has excellent physical properties for this application, but unfortunately, it is easily deformed and damaged by rough handling. Dings and dents on the exterior will not affect function, but deformations where the coldfinger and tubes enter the body can cause leaks and poor performance. Take measures to protect these areas from accidental impact and prevent the movement of connected parts. Three passages, or "ports", are machined into one face of the VTC to accept tubing. Looking at that face, the left port is for compressed air, the center port is the LN drain, and the right port is for the LN supply. All tubing is 1/4-inch in diameter. The LN supply tubing should be made of FEP. The other tubes can be of any convenient plastic; polyurethane and LLDPE are excellent options. The ports are machined slightly undersize to create a snug fit on newly inserted tubing. Repeatedly inserting and removing the tubing will enlarge the port and should be avoided as much as possible. A clear, plastic "tube hitch", with holes matching the port positions, is provided with the VTC to secure the tubing in place. Also provided is a short, bent drain tube. (A longer tube may be used, if preferred, to direct the drained LN to a specific location.) Use the following procedure to install the tubes: # Before installing the tubes, slightly chamfer the outer edge of the tube end so it will not gouge the interior of the passage during insertion. (A hand held pencil sharpener serves well for this.) # Make sure the tube hitch is oriented to match the port holes. Pass the tube ends to be inserted through the appropriate holes in tube hitch, so they protrude into the hitch. # Install a 1/4-inch circlip on each tube, on the interior side of the hitch, taking care to not scratch the tubes, or over-stretch the circlip. The circlip has two functions: it is a depth stop, and it prevents the tube from being pulled through the hitch and out of the port. #: NOTE: The LN drain tube must be inserted into its port a fairly precise depth, as close to 11 mm (0.43 inches) as possible. Install its circlip 11 mm from the end. The air and LN supply tubes may be inserted anywhere from 11 to 20 mm. # Insert the tubes into their respective ports, gently working them into place. It is easier to insert them each little by little than to finish one before moving to another. Avoid introducing any side forces on the tubes in the ports. Stop when the circlips reach the VTC body. # Slide the hitch along the tubes up to the circlips, wrap the hitch around the VTC body and snap the hitch ends together. Insert a thin, flat, hard support (such as a metal ruler) under the hitch snap to keep it from denting the VTC body.
Summary:
Please note that all contributions to Aeon HACS Wiki may be edited, altered, or removed by other contributors. If you do not want your writing to be edited mercilessly, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource (see
Aeon HACS Wiki:Copyrights
for details).
Do not submit copyrighted work without permission!
Cancel
Editing help
(opens in new window)