Inline LN Phase Separator Funnel Creation

    3D Model    About this item    Product info

---

1. Grab heatshrink FEP 0.38 1:6:1 clear, and cut desired number of 4 inch pieces on paper cutter.
   • Keep edges square.
2. Using the inline PS forming tool, slide the stock down over the top of the tool.
3. Use a scrap piece of FEP tubing, and slide it over the metal end of the tube to ensure the stock doesn't form to small.
4. Slide the stock funnel over the FEP tube so the top of the funnel aligns with the cut line groove on the metal.
5. Use the heat gun to form the heatshrink FEP evenly around the FEP tube and forming tool.
   • Try not to heat for too long at risk of melting the plastic tool.
6. Slide the funnel off of the forming tool and remove the FEP tube.