Control Box Panel Creation

    3D Model    About this item    Product info

---

1. Stock should always be 1.0 from extreme left and flush with back.
2. With haircell side UP and bottom edge of stock to the left, run "countersunk holes".
3. Rotate stock 180 so top edge of stock is to the left, continue program.
4. With haircell side UP and top edge of stock to the back, run "inlet".
5. Rotate stock 180 so bottom edge of stock is to the back, continue program.
6. With haircell side DOWN and bottom edge of stock to the back, run "power".