Actuator LN Valve Creation

    3D Model    About this item    Product info

---

1. Open the serial port terminal.
2. Plug the test actuator controller into a computer.
3. Plug the CPW servo into the controller.
4. Command g1000.
5. Disconnect the servo.
6. Install an LN valve stem onto the servo drive spline with the orientation mark facing the servo label.
7. Install an LN valve stem collar, chamfered ID first.
8. Press the collar down into contact with the servo gear cover using the collar pusher (TL-LNVSCP).
   • NOTE: Do not assemble screws and servo t-nut onto valve yet, will be assembled when making LN manifold assembly.