Jump to content

Tee SS 1/4 Ported Creation

From Aeon HACS Wiki
Revision as of 16:16, 17 February 2024 by Anna.b (talk | contribs) (added about this item link to nav bar)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
    3D Model    About this item    Product info


  1. Setup the MV35 to hold a Tee SS 1/4.
  2. Remove the nuts and ferrules from the tee.
  3. Use ported tee 250.mv35 to machine the tee.
  4. Remove the burr on the inside of the tee.
  5. Clean the oil off of the tee.
  6. Put the nuts and ferrules back on the tee.