Heater Controller Stack Base Creation

    About this item    Product info

---

Instructions

Heater controller stack base exploded

1. Prepare the components

   Ensure all components are available

2. Mount the principal CCA heater controller 6 channel v.C

   Place the CCA heater controller 6 channel v.C on a clean, flat workspace

   Ensure the mounting holes are aligned and ready for the next step

3. Attach the CCA stack power boards

   Take the first CCA stack power board and align it on one side of the heater controller 6 channel v.C

   Ensure that the connectors and mounting holes are properly aligned

   Secure the CCA stack power board in place using the appropriate fasteners

   Repeat this process for the second CCA stack power board on the opposite side of the heater controller 6 channel v.C

4. Install the nylon standoffs

   Locate the four corner mounting holes on the CCA heater controller 6 channel v.C

   Attach the nylon standoffs 4-40 x 1/4 hex x 1/2 to each of the four corners, ensuring they are securely fastened

   These standoffs will provide the necessary spacing and support for the assembly, ensuring proper alignment when installed into the system

5. Final check

   Verify that all components are securely attached and properly aligned

   Ensure that all connections between the heater controller 6 channel v.C and the CCA stack power boards are tight and functioning correctly