Actuator Medium Flow Valve Creation
Instructions
- Prepare Components:
- Ensure all components are clean and free of debris.
- Gather the following components: Serial Actuator and Frame, Servo Wheel Coupling Driver, Actuator Coupling 4MFV, Screw M3 x 6 PH 5.3 mm dia head, and Actuator Frame Bearing 4MFV.
- Assemble the Actuator:
- Start with the Serial Actuator and Frame as the top component.
- Attach the Servo Wheel Coupling Driver to the Serial Actuator and Frame. Ensure it is securely fitted.
- Install the Coupling:
- Position the Actuator Coupling 4MFV below the Servo Wheel Coupling Driver. Align it properly to ensure smooth operation.
- Secure the Assembly:
- Insert the Screw M3 x 6 PH 5.3 mm dia head through the Actuator Coupling 4MFV and into the Servo Wheel Coupling Driver. Tighten the screw to secure the coupling and the wheel in place.
- Attach the Bearing:
- Place the Actuator Frame Bearing 4MFV at the bottom of the assembly. Ensure it is properly aligned and securely attached to provide stability to the entire actuator assembly.
- Final Checks:
- Verify that all components are securely fastened and properly aligned.
- Ensure that the actuator operates smoothly without any obstructions or misalignments.