Actuator LN Valve Creation
Instructions
- Open the serial port terminal.
- Ensure the serial port terminal is open on your computer.
- Connect the Test Actuator Controller.
- Plug the test actuator controller into the computer.
- Connect the servo.
- Attach the CPW servo to the controller.
- Command the servo.
- Enter the command 'g1000' in the terminal to initialize the servo.
- Disconnect the servo.
- Safely disconnect the servo from the controller.
- Install the LN valve stem
- Attach the LN valve stem onto the servo drive spline, ensuring the orientation mark is facing the servo label.
- Install the LN valve stem collar
- Place the LN valve stem collar onto the valve stem with the chamfered ID first.
- Secure the collar
- using the collar pusher tool (TL-LNVSCP), press the collar down into contact with the servo gear cover.
Notes:
- Do not assemble the screws and servo T-nut onto the valve at this stage. These will be assembled during the LN manifold assembly process.