Grounding Kit Creation

1. Drill a 0.265" hole in the plastic backing of the control kit, 1" to the right and 0.75" above the screw to the right of the lowest set of quick disconnect plugs. Refer to the model if unsure of the size of the hole or the exact location of the hole.
2. Place a 1/4-20 x 1.25 SS SS screw in the hole, with a 1/4-20 nut and 1/4 washer in the front and back to anchor it.
3. Route 14 gauge green wire from the screw to three locations.
   1. The quick disconnect ground plug in the neighboring group to the left and below
   2. The ground pin on the 15V power supply. This should be daisy-chained with a 22 gauge green wire to the 5V power supply as well.
   3. A spot on the frame above the auxiliary ports (a different ground wire will likely be attached there, replace with this one)

1. Use a quick disconnect female terminals for the first wire, fork terminals for the power supply wires, and a ring terminal for the frame attached wire.