Actuator Frame Bearing 4BSV Creation

3D Model    About this item    Product info

---

1. Setup the MV35 so that it will hold the actuator frame bearing.
2. Grab an actuator bearing blank and place it into the setup.
3. Run the program.
   • It is most efficient to do the same step on multiple blanks then move onto a different step.
4. Run all of the programs required to turn the blank into the needed part.
5. Use the model to place a hole in the correct spot.
6. Tap the bearing with a 6-32 bit.
7. Insert a screw 6-32 x 1/4 SS SS.