Jump to content

GR Bank Swing Set Creation

From Aeon HACS Wiki
Revision as of 15:53, 25 February 2024 by Anna.b (talk | contribs) (updated nav bar to template)
    3D Model    About this item    Product info

  1. Attach a shaft collar to the GR bank hinge on the outside of the hinge mount.
    Do NOT fully tighten yet, have only slightly tightened
  2. Take one GR hinge mount and slide the GR bank hinge through the larger hole.
    1. The tabbed end should be facing outward on the hinge mount.
    2. Make sure all required holes are tapped on the hinge mount.
  3. Use the model to place the acetal spacers and swings on in the correct places.
  4. Place the spring disk on and orient it so the concave bend of the spring is pressed up and being squished by the hinge mount.
  5. Place the second hinge mount on the bar.
  6. Tighten another shaft collar to the outside of the last hinge and try to make both sides stick out of the hinge mounts symmetrical.
  7. Attach to the system frame and align with plumbing.
  8. Attach a swing stop bar to the top (middle set of holes), and to the bottom (front set of holes) using the listed screws from the IDB.
    1. Before tighten the bars fully make sure that the bars are positioned well.
  9. Make sure that the center of the furnaces lines up with the furnace arm.
    1. The bracket can be bent to better aline this.
    2. In the end the furnace should still line up with the plumbing and the TC cable should still point towards the frame.