Jump to content

LN Manifold Body 11 Port Creation

From Aeon HACS Wiki
Revision as of 14:43, 28 May 2024 by 73.24.216.92 (talk) (Created page with "= Work offsets = # O0014: fence = Programs = # O0761: cover # O0762: cavity # O0763: port holes = Tooling = # T0002: 7/32 end mill, 4-flute # T0009: 0.125 drill # T0011: 0.078 end mill, 3-flute # T0015: 1/8 end mill, 2-flute # T0016: 0.25 end mill, 2-flute # T0017: 3/8 end mill, 2-flute # T0018: 1/2 end mill, 2-flute # T0021: 1 x 4 end mill, 2-flute # T0023: 0.180 drill = Stock (inches) = # Blank: 11.5 x 2.75 x 5.5 = Finished dimensions (inches) = # Lid: 11.5 x 2.75...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Work offsets

  1. O0014: fence

Programs

  1. O0761: cover
  2. O0762: cavity
  3. O0763: port holes

Tooling

  1. T0002: 7/32 end mill, 4-flute
  2. T0009: 0.125 drill
  3. T0011: 0.078 end mill, 3-flute
  4. T0015: 1/8 end mill, 2-flute
  5. T0016: 0.25 end mill, 2-flute
  6. T0017: 3/8 end mill, 2-flute
  7. T0018: 1/2 end mill, 2-flute
  8. T0021: 1 x 4 end mill, 2-flute
  9. T0023: 0.180 drill


Stock (inches)

  1. Blank: 11.5 x 2.75 x 5.5

Finished dimensions (inches)

  1. Lid: 11.5 x 2.75 x 1.25, w/ 0.1875 holes
  2. Body: 11.5 x 2.75 x 4.0, w/ 0.5 holes

Instructions

  1. Reference face: left
  2. Run 'lid' on top face
  3. Separate lid from body using bandsaw
    1. Part lid at 1.25"
    2. Size body to 4"
  4. Run 'cavity' on top face of 'body'
  5. Run 'stem holes' on back face of 'body'
    • (CHECK TO SEE IF TOOL 23 HAS THE CORRECT TOOL LOADED BEFORE RUNNING THIS)
  6. Run 'drain holes' on bottom face of 'body'
  7. Run 'lid 2nd op' on right face of 'body'
Retrieved from "https://aeonhacs.com/wiki/index.php?title=LN_Manifold_Body_11_Port_Creation&oldid=941"