Actuator Frame Bearing 4BSV Creation: Difference between revisions

From Aeon HACS Wiki
VisualWikitext
mNo edit summary
No edit summary
Line 3: Line 3:
|about=Actuator_Frame_Bearing_4BSV
|about=Actuator_Frame_Bearing_4BSV
|product=actuator+frame+bearing+4BSV}}
|product=actuator+frame+bearing+4BSV}}
# Follow the vice setup as indicated by the MV35 so that it will hold the actuator frame bearing. Ensure that any parallels or spring wedges are cleared of the area to be drilled.
# This part is milled in the MV35, follow the instructions within the program.
# Grab an actuator frame bearing blank and place it into the setup.
# Run the program. Follow directions as indicated within the program.
#* It is most efficient to do the same step on multiple blanks then move onto a different step.
# Use the mill to drill a 0.107 inch hole through the center of one side. Follow the model to find the correct position.
# Use the mill to drill a 0.107 inch hole through the center of one side. Follow the model to find the correct position.
# Tap the hole with a 6-32 bit.
# Tap the hole with a 6-32 bit.
# Insert a screw 6-32 x 1/4 SS SS.
# Insert a screw 6-32 x 1/4 SS SS.

Revision as of 15:35, 28 May 2024

    3D Model    About this item    Product info
  1. This part is milled in the MV35, follow the instructions within the program.
  2. Use the mill to drill a 0.107 inch hole through the center of one side. Follow the model to find the correct position.
  3. Tap the hole with a 6-32 bit.
  4. Insert a screw 6-32 x 1/4 SS SS.
Retrieved from "https://aeonhacs.com/wiki/index.php?title=Actuator_Frame_Bearing_4BSV_Creation&oldid=955"