Actuator Coupling 4LFV Creation: Difference between revisions
(updated about this item link after creating its page) |
(updated nav bar to template) |
||
| Line 1: | Line 1: | ||
{{Item navbar | |||
|model=https://cad.onshape.com/documents/a2590672ece11180cd4d60d0/w/180034e6f61eac6669ee5961/e/f8024e3238c01a36d461e9b2?configuration=List_DTwLl7wsXTKpkn%3D_4LFV&renderMode=0&uiState=65ba8dd4dd682e566155eeda | |||
|about=Actuator_Coupling_4LFV | |||
|product=actuator+coupling+4LFV}} | |||
# Cut blanks on table saw to 1.7 inch. | # Cut blanks on table saw to 1.7 inch. | ||
# Follow the steps inside of the coupling instructions. | # Follow the steps inside of the coupling instructions. | ||
# Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole. | # Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole. | ||
# .285 inch from the top face create a .107 inch hole that goes all the way to the center of the previous hole. | # .285 inch from the top face create a .107 inch hole that goes all the way to the center of the previous hole. | ||
# Use 6-32 x 1<nowiki>/</nowiki>4 tap to thread the hole. | # Use 6-32 x 1<nowiki>/</nowiki>4 tap to thread the hole. | ||
# Insert screw 6-32 x 1/4 SS SS (92311A144) | # Insert screw 6-32 x 1/4 SS SS (92311A144) | ||
Revision as of 10:28, 25 February 2024
- Cut blanks on table saw to 1.7 inch.
- Follow the steps inside of the coupling instructions.
- Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole.
- .285 inch from the top face create a .107 inch hole that goes all the way to the center of the previous hole.
- Use 6-32 x 1/4 tap to thread the hole.
- Insert screw 6-32 x 1/4 SS SS (92311A144)