Heater Controller Stack Base Creation: Difference between revisions
No edit summary |
No edit summary |
||
| Line 3: | Line 3: | ||
|about=Heater_Controller_Stack_Base | |about=Heater_Controller_Stack_Base | ||
|product=heater+controller+stack+base}} | |product=heater+controller+stack+base}} | ||
== Instructions == | == Instructions == | ||
[[File:Heater controller stack base exploded view.png|alt=Heater controller stack base exploded view|thumb|Heater controller stack base exploded]] | |||
# Prepare the components | # Prepare the components | ||
#: Ensure all components are available | #: Ensure all components are available | ||
Latest revision as of 14:26, 21 August 2024
Instructions
- Prepare the components
- Ensure all components are available
- Mount the principal CCA heater controller 6 channel v.C
- Place the CCA heater controller 6 channel v.C on a clean, flat workspace
- Ensure the mounting holes are aligned and ready for the next step
- Attach the CCA stack power boards
- Take the first CCA stack power board and align it on one side of the heater controller 6 channel v.C
- Ensure that the connectors and mounting holes are properly aligned
- Secure the CCA stack power board in place using the appropriate fasteners
- Repeat this process for the second CCA stack power board on the opposite side of the heater controller 6 channel v.C
- Install the nylon standoffs
- Locate the four corner mounting holes on the CCA heater controller 6 channel v.C
- Attach the nylon standoffs 4-40 x 1/4 hex x 1/2 to each of the four corners, ensuring they are securely fastened
- These standoffs will provide the necessary spacing and support for the assembly, ensuring proper alignment when installed into the system
- Final check
- Verify that all components are securely attached and properly aligned
- Ensure that all connections between the heater controller 6 channel v.C and the CCA stack power boards are tight and functioning correctly