Actuator Frame Bearing 4MFV Creation: Difference between revisions
No edit summary |
No edit summary |
||
Line 6: | Line 6: | ||
== Instructions == | == Instructions == | ||
# This part is milled in the MV35, follow the instructions within the program. | # This part is milled in the MV35, follow the instructions within the program. | ||
# Drill a | # Drill a 0.567" inch hole on the top of the bearing. | ||
# Drill a | # Drill a 0.935" inch hole on the top (Do not go all the way through). | ||
=== Notes: === | === Notes: === | ||
* Follow the model to find the correct position. | * Follow the model to find the correct position. |
Revision as of 14:40, 25 July 2024
Instructions
- This part is milled in the MV35, follow the instructions within the program.
- Drill a 0.567" inch hole on the top of the bearing.
- Drill a 0.935" inch hole on the top (Do not go all the way through).
Notes:
- Follow the model to find the correct position.