Actuator LN Valve Creation: Difference between revisions
No edit summary |
No edit summary |
||
Line 3: | Line 3: | ||
|about=Actuator_LN_Valve | |about=Actuator_LN_Valve | ||
|product=actuator+LN+valve}} | |product=actuator+LN+valve}} | ||
[[File:Actuator LN valve exploded (onshape).png|alt=Actuator LN valve exploded|thumb|Actuator LN valve exploded | [[File:Actuator LN valve exploded (onshape).png|alt=Actuator LN valve exploded|thumb|Actuator LN valve exploded]] | ||
== Instructions == | == Instructions == |
Revision as of 13:31, 17 July 2024
Instructions
- Open the serial port terminal.
- Plug the test actuator controller into a computer.
- Plug the CPW servo into the controller.
- Command g1000.
- Disconnect the servo.
- Install an LN valve stem onto the servo drive spline with the orientation mark facing the servo label.
- Install an LN valve stem collar, chamfered ID first.
- Press the collar down into contact with the servo gear cover using the collar pusher (TL-LNVSCP).
- NOTE: Do not assemble screws and servo t-nut onto valve yet, will be assembled when making LN manifold assembly.