Actuator LN Valve Creation: Difference between revisions
(Added instruction info, markup lang, link nav bar, updated 3d model and product info links; about this item still pending) |
(canceled uploading image) |
||
Line 8: | Line 8: | ||
# Install an LN valve stem onto the servo drive spline with the orientation mark facing the servo label. | # Install an LN valve stem onto the servo drive spline with the orientation mark facing the servo label. | ||
# Install an LN valve stem collar, chamfered ID first. | # Install an LN valve stem collar, chamfered ID first. | ||
# Press the collar down into contact with the servo gear cover using the collar pusher (TL-LNVSCP). | # Press the collar down into contact with the servo gear cover using the collar pusher (TL-LNVSCP). | ||
#* NOTE: Do not assemble screws and servo t-nut onto valve yet, will be assembled when making LN manifold assembly. | #* NOTE: Do not assemble screws and servo t-nut onto valve yet, will be assembled when making LN manifold assembly. |
Revision as of 12:13, 3 February 2024
3D Model [SUMMARYPG About this item] Product info
- Open the serial port terminal.
- Plug the test actuator controller into a computer.
- Plug the CPW servo into the controller.
- Command g1000.
- Disconnect the servo.
- Install an LN valve stem onto the servo drive spline with the orientation mark facing the servo label.
- Install an LN valve stem collar, chamfered ID first.
- Press the collar down into contact with the servo gear cover using the collar pusher (TL-LNVSCP).
- NOTE: Do not assemble screws and servo t-nut onto valve yet, will be assembled when making LN manifold assembly.