Actuator Frame Bearing 4MFV Creation: Difference between revisions
No edit summary |
No edit summary |
||
Line 3: | Line 3: | ||
|about=Actuator_Frame_Bearing_4MFV | |about=Actuator_Frame_Bearing_4MFV | ||
|product=actuator+frame+bearing+4MFV}} | |product=actuator+frame+bearing+4MFV}} | ||
[[File:Actuator frame bearing 4MFV exploded.png|alt=Actuator frame bearing 4MFV exploded|thumb|Actuator frame bearing 4MFV exploded]] | |||
== Instructions == | == Instructions == |
Revision as of 14:42, 25 July 2024
Instructions
- This part is milled in the MV35, follow the instructions within the program.
- Drill a 0.567" inch hole on the top of the bearing.
- Drill a 0.935" inch hole on the top (Do not go all the way through).
Notes:
- Follow the model to find the correct position.