Actuator Frame Bearing 4BSV Creation: Difference between revisions
No edit summary |
No edit summary |
||
Line 3: | Line 3: | ||
|about=Actuator_Frame_Bearing_4BSV | |about=Actuator_Frame_Bearing_4BSV | ||
|product=actuator+frame+bearing+4BSV}} | |product=actuator+frame+bearing+4BSV}} | ||
[[File:Actuator frame bearing 4BSV (creation)2.png|alt=Actuator frame bearing 4BSV (creation)2|thumb|Actuator frame bearing 4BSV (creation)2]] | |||
== Instructions == | == Instructions == |
Revision as of 13:24, 25 July 2024
Instructions
- This part is milled in the MV35, follow the instructions within the program.
- Drill a 0.652 inch hole on the top of the bearing.
- Drill a 0.107 inch hole through the center of one side.
- Tap the hole with a 6-32 bit.
- Insert a screw 6-32 x 1/4 SS SS.
Notes:
- Follow the model to find the correct position.