Actuator Frame Bearing 4MFV Creation: Difference between revisions

From Aeon HACS Wiki
VisualWikitext
(updated nav bar to template)
No edit summary
 
(6 intermediate revisions by 2 users not shown)
Line 3: Line 3:
|about=Actuator_Frame_Bearing_4MFV
|about=Actuator_Frame_Bearing_4MFV
|product=actuator+frame+bearing+4MFV}}
|product=actuator+frame+bearing+4MFV}}
# Setup the MV35 so that it will hold the actuator frame bearing.
 
# Grab an actuator bearing blank and place it into the setup.
== Instructions ==
# Run the program.
[[File:Actuator frame bearing 4MFV exploded.png|alt=Actuator frame bearing 4MFV exploded|thumb|Actuator frame bearing 4MFV]]
#* It is most efficient to do the same step on multiple blanks then move onto a different step.
# This part is milled in the MV35, follow the instructions within the program.
# Run all of the programs required to turn the blank into the needed part.
# Drill a 0.567" inch hole on the top of the bearing.
# Drill a 0.935" inch hole on the top (Do not go all the way through).
 
=== Notes: ===
* Follow the model to find the correct position.

Latest revision as of 15:23, 25 July 2024

    3D Model    About this item    Product info

Instructions

Actuator frame bearing 4MFV exploded
Actuator frame bearing 4MFV
  1. This part is milled in the MV35, follow the instructions within the program.
  2. Drill a 0.567" inch hole on the top of the bearing.
  3. Drill a 0.935" inch hole on the top (Do not go all the way through).

Notes:

  • Follow the model to find the correct position.
Retrieved from "https://aeonhacs.com/wiki/index.php?title=Actuator_Frame_Bearing_4MFV_Creation&oldid=1949"