Actuator Coupling 4LFV Creation: Difference between revisions

Latest revision as of 14:45, 24 July 2024

Cut Acetal Black Rod 750 on table saw to 1.7 inch.
This part is milled on the MV35, follow the instructions within the program.
Use the coupling drill fixture 0.75 in the mill to drill a cross hole.
0.285 inch from the top face create a 0.107 inch hole that goes into the center cavity.
Use a 6-32 tap to thread the hole.
Insert screw 6-32 x 1/4 SS SS.

@@ Line 3: / Line 3: @@
 |about=Actuator_Coupling_4LFV
 |product=actuator+coupling+4LFV}}
-# Cut blanks on table saw to 1.7 inch. [[File:Actuator coupling 4LFV 3d model.png|alt=3d model of a actuator coupling 4LFV.|thumb|3d model of a actuator coupling 4LFV.]]
-# Follow the steps inside of the coupling instructions.
+== Instructions ==
-# Use the coupling drill fixture 0.75 (TL-CDF750) in the mill to drill a cross hole.
+[[File:Actuator coupling 4LFV exploded.png|alt=black cylinder with screw exploded|thumb|Actuator coupling 4LFV exploded]]
-# .285 inch from the top face create a .107 inch hole that goes all the way to the center of the previous hole.
+# Cut Acetal Black Rod 750 on table saw to 1.7 inch.
-# Use 6-32 x 1<nowiki>/</nowiki>4 tap to thread the hole.
+# This part is milled on the MV35, follow the instructions within the program.
-# Insert screw 6-32 x 1/4 SS SS (92311A144)
+# Use the coupling drill fixture 0.75 in the mill to drill a cross hole.
+#: 0.285 inch from the top face create a 0.107 inch hole that goes into the center cavity.
+# Use a 6-32 tap to thread the hole.
+# Insert screw 6-32 x 1/4 SS SS.